Raymarine E70361 Installation Instructions Manual page 57

8. Press the Right button to display the Autonetworking page.
9. Press the Set up button to begin the Autonetworking procedure.
A countdown will begin and the chosen display shows 'WAIT' and then 'JOIN' as devices join
the network.
10. In the last 30 seconds of the countdown some displays may switch on and 'JOIN' will flash
onscreen, to allow these displays to join the network follow the steps below:
i. Press any button on a display that has 'JOIN' flashing onscreen.
The Display will show 'JOIN YES'
ii. Confirm by pressing any button on the same display.
The display will show 'DONE'.
If confirmation is not completed within 25 seconds, 'FAIL' will be shown which means the display
has not joined the network.
When the countdown is complete, the chosen display returns to the Autonetworking page. Press
and hold the Set up button for 2 seconds to return to normal operation.
11. Test the system:
i. Switch off the chosen display.
System operation and setup
57