Raymarine E70361 Installation Instructions Manual page 51

2. Place the small sealing ring in the groove located on the bottom of the mounting tray.
3. Position the Mounting tray on top of the Riser.
4. Secure the Mounting tray to the Riser using 3x supplied fixings.
5. Place the large sealing ring into the groove on the upper side of the Mounting tray.
6. Pull the SeaTalkng ® cable through the Riser and Mounting tray. Plug in the cable connector on
the underside of the unit and secure by rotating the locking collar clockwise 2 clicks.
7. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
8. Place the Mounting trim over the unit slightly offset, and then twist the Mounting trim clockwise
until it locks into position.
Installation 51