Setting The Alarm Mode; Switching Off The Alarm - Philips Docking Entertainment System DC310 User Manual

SETTING THE ALARM TIME (See 3)
1 In any mode, press and hold ALM1 or ALM2 for two seconds.
™ ALM1 / ALM2 icon and the hour digits flash. And the icon for the current
alarm mode also flashes.
2 Hold down or press ¡1 / 2™ repeatedly to set and adjust the hours.
3 Press ALM1 or ALM2 to confirm.
™ ALM1 / ALM2 icon and the minutes digits flash. And the icon for the cur-
rent alarm mode also flashes.
4 Hold down or press ¡1 / 2™ repeatedly to set and adjust the mintues.
5 Press ALM1 or ALM2 to confirm.

SETTING THE ALARM MODE

1 Press POWER to switch to standby mode.
2 Select your choice of alarm mode: either docked player (only available to iPod),
buzzer, or radio by using the iPod
• At the set alarm time, the docked player (only available to iPod) or radio or
buzzer will switch on automatically.
Helpful hints:
– If you have selected RADIO alarm mode, make sure you have properly tuned to a
station before turning off the set.
– If you have selected iPod alarm mode, make sure you have docked the compatible
player, or the buzzer mode will be selected automatically.
– To check the alarm time setting for ALM1 or ALM2, press ALM1 or ALM2.

SWITCHING OFF THE ALARM

There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 59
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain
the same alarm setting for the following day:
• Press POWER.
• •
BUZZER RADIO slider.