Table of Contents
Advertisement
Completing the Configuration Setup Wizard
Procedure
Step 1
Verify that no devices are connected to the switch. Initially, the switch acts as a DHCP server.
Step 2
The switch is in Standalone mode when it is powered on.
Step 3
LEDs remain off by default when switch is powered on. Press the Mode button to turn on the LEDs. You can
also turn on LEDs using the mobile application Digital Building-Installer .
Step 4
Confirm that the STAT LED is solid green. This indicates that POST is complete. If the STAT LED turns
amber, the device failed POST. Reconnect the AC power cord to the AC power connector of your device and
to a grounded AC outlet. If the STAT LED still does not turn green, contact your Cisco representative or
retailer.
Step 5
Connect a straight-through Category 5 Ethernet cable to a 10/100 Ethernet port on the switch front panel and
to the Ethernet port on the PC.
Step 6
Verify that the port LEDs on the PC and on your device are solid green or blinking green. This indicates a
successful connection.
Step 7
Wait 30 seconds.
Step 8
To log on to the device using an Internet browser on your PC, type the IP address 10.0.0.1 or 10.0.0.3 in the
address bar of your Internet browser, if the switch is in network mode, and press Enter. Type the IP address
172.16.0.1 in the address bar of your Internet browser, if the switch is in standalone more and press Enter.
Step 9
Type the following default credentials: username: cisco, password: cisco and press Enter.
We recommend you to change default credentials after logging in.
The Configuration Setup wizard is displayed. Click Go to Wizard.
Completing the Configuration Setup Wizard
Completing the Configuration Setup Wizard enables you to set up your device with the minimum configuration
required to enable traffic to pass through the network. To achieve this, you must complete the following setup
tasks as you proceed with the Configuration Setup Wizard.
• Basic Device Settings
• Interfaces
• Layer 3 Settings
• Advanced Device Settings
For more information on the configuration steps involved in completing the Configuration Setup Wizard, see
User Guide for Cisco Configuration Professional for Catalyst .
Catalyst Digital Building Series Switch Hardware Installation Guide
94
Configuring the Switch
Advertisement
Table of Contents
