Table of Contents
Advertisement
Disassembly
28
IMPORTANT
To properly replace the display lens, a new adhesive strip and a lens press is used.
11. To replace, using the lens press, properly align the display lens onto the adhesive strip.
Then press into place.
12. Carefully place the metal shield over the display lens and press firmly into place.
13. Align the display module assembly to the flip assembly.
14. Carefully lower the display module into the flip assembly. Ensure that all of the display
none of the display assembly components are damaged.
15. Align the flip display flex to the flex connector on the flip display assembly and gently
press down on the flex connector until properly seated.
16. Replace the camera assembly, flip assembly cover, transceiver board, rear housing,
antenna, USIM, battery, and battery connector as described in the procedures.
September 26, 2006
V3xx
6809505A63-O
Advertisement
Table of Contents
