Table of Contents
Advertisement
Level 1 and 2 Service Manual
G
6809505A63-O
4.
Carefully rotate the rear housing away from the front housing and flip assembly. The flip
flex connector will disconnect when the rear housing is removed.
Figure 6. Removing the Rear Housing Assembly
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
5.
Use the disassembly tool to unseat the two flex connectors from it's socket.
6.
Lift the rear housing assembly away from the phone.
7.
To replace, carefully align the two flex connectors to their respective socket on the rear
housing assembly, then gently press down on each of the two flex connectors until they
are properly seated in their own socket.
8.
Rotate the rear housing assembly so it sits over the phone.
9.
Align the housing latches with the corresponding openings on the front housing. Gently
press the housings together until the catches snap into place.
10. Replace the 2 housing screws and tighten to a final torque setting of 1.7 inch pounds. Do
not over tighten.
11. Replace the USIM, memory card, battery, and battery cover as described in the procedures.
September 26, 2006
FLEX Connector
Disassembly
FLEX Connector
061466o
19
Advertisement
Table of Contents
