Cisco UC500 series Configuration Manual page 22

4.3.13a Click "Internet Connection" from the left panel to configure the WAN interface
with a appropriate WAN IP address option. This is a mandatory step when using CCA
for UC500 configuration. Click the "FastEthernet 0/0" interface and then the "Modify"
button. In this example – a static IP is being used (1.1.100.4). However, based on the
network setup, DHCP can also be used as well as PPPoE for DSL. Click "OK" to go back
to the Internet Connection pane.
Figure 4.3.13a WAN connection
Click "OK" to continue.
© 2008 Cisco Systems, Inc. All rights reserved.