Cisco UC500 series Configuration Manual page 15

4.3.6 In this setup – there is a single phone connected to the UC500. To configure the
UC500 – click on "Configure"
Figure 4.3.6 Left pane showing Configure options
The configuration elements that need to be modified or kept at default from now on are
defined per the VAR / customer. The focus for now will be on common SIP Trunk
configuration features that need to be changed.
"Smartports" configuration option allows changing data and voice VLAN assignments
from the recommended defaults that are assumed in this document to something else.
"Ports" allows the assignment of static duplex and speed settings, power management,
and enablement.
"Security" allows the creation or modifications of NAT, VPN server and Firewall
options. This will not be addressed in this document but are discussed in the UC500
product documentation.
"Telephony" is where the majority of configuration for SIP Trunking takes place, and
will be addressed in the next section of this document.
Cisco recommends that VARs leave the "Switching", "Routing", "Smartports" & "Ports"
portions at their default settings unless integration into the provider network requires the
addition of IP interfaces, VLANs or static routing decisions etc.
© 2008 Cisco Systems, Inc. All rights reserved.
on the Left pane – this should show up as below: