Shark® 100T Quickstart Shark® 100T Quickstart Guide Mechanical Installation 4.78" [12.10cm] 4.16” 0.62” [10.60cm] [1.61cm] DIN Rail with black rubber stoppers Release clip 0.91" 3.25” 100T [2.31cm] DIN Installation [8.26cm] Dimensions Installation Steps: Slide top of groove of meter onto DIN Rail. Press gently until the meter clicks into place. If mounting with DIN Rail provided, use Black Rubber Stoppers (also provided) shown above.
Page 2
100T meter’s RS485 port uses standard 2-wire, half duplex architecture. Factory Initial Default Settings: When the Shark 100T is powered up, for 10 seconds you can connect to the meter using the Factory Default Settings (even if the Device Profile has been changed). After 10 seconds the Device Profile reverts to the actual Device Profile in use.
Page 3
Set Pt-n value as 345, Pt-d value as 69, Pt-S value as 1000. Update Device: 8.When changes are complete, click the Update button to send a new profile to the Shark 100T meter. 9.Click Cancel to Exit the profile (or) click other tabs to update other screens.
Page 4
Shark® is a registered trademark of Electro Industries/GaugeTech. The distinctive shape, style, and overall appearance of the Shark® meter is a trademark of Electro Industries/GaugeTech. Windows® is a registered trademark of Microsoft Corporation in the United States and/or other countries.