Kenmore 790.9010 series Use & Care Manual page 26

General Cleaning
To Remove and Replace Oven Door
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and engage it in the hinge levers. You may have to apply a
little downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while turning the top of the door toward the range to
completely disengage the hinge levers.
4. To replace the door, reverse the door removal steps. Make sure the hinge supports are fully engaged before
unlocking the hinge levers.
The door is heavy. After removing door, lay it fl at on the fl oor with its inside facing down.
Hinge lever
Lock in
Hinge
normal position
Support
To Remove and Replace Storage Drawer
To Remove the Drawer:
1. Pull the empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To Replace the Drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers
to clear the roller guide stop, and push in.
Hook
Lock engaged
for door removal
Rails
26
Hinge Slot
Door removed
from range
Storage
Drawer
Roller
Front Frame