Specific Safety Rules For Log Splitters - Yard Works 60-3800-4 Instruction Manual

YW Log Split 60-3800-4 E
General Safety Rules - continued
13. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in working
order.
14. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts,
binding, breakage, or any other conditions that may affect the tool's
operation. Any part that is damaged should be properly repaired or
replaced before use.

Specific Safety Rules for Log Splitters

1. IF YOU ARE NOT thoroughly familiar with the operation of the log splitter,
obtain advice from a qualified person.
2. MAKE SURE wiring codes and recommended electrical connections are
followed. When servicing, use only identical replacement parts. Disconnect
log splitter from the power source before making adjustments or repairs.
3. Place the log splitter on a stable, flat, and level work surface where there is
plenty of room for handling logs.
4. INSPECT THE LOG SPLITTER before each use. Keep guards in place
and in working order. Replace damaged, missing, or failed parts before
using.
5. Do not alter the log splitter. Altering the tool or exceeding its design
capabilities and capacities could result in serious injury or fatality and will
void the warranty.
6. MAKE SURE THE EXTENSION CORD is no longer than 33' (10 m) and is
rated for outdoor use. Ground the log splitter and avoid contact with
grounded surfaces during operation.
7. MAKE all adjustments with the switch in the OFF position and the log
splitter disconnected from the power source.
1/3/04 2:20 PM Page 4
ALWAYS WEAR EYE PROTECTION.
A log splitter can throw foreign objects into your eyes which
could cause permanent eye damage.
ALWAYS wear safety goggles (not glasses). Ordinary
eyeglasses have only impact-resistant lenses—they are
NOT safety goggles.
SAVE THESE SAFETY RULES
4