Docking Entertainment System Register your product and get support at www.philips.com/welcome DC315 User manual...
Important Safety Important Safety Instructions Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliﬁers) that produce heat.
Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualiﬁed service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
If the mains plug contains a fuse, this should have a value of 3 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 3 Amp. Note: The severed plug must be disposed off to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.
2004/108/EC + 2006/95/EC Any changes or modiﬁcations made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Recycling Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Your Docking Entertainment System Congratulations on your purchase, and welcome to Philips! To fully beneﬁt from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can enjoy audio from the iPod, iPhone, other audio devices, or the radio.
• Start or pause iPod/iPhone play. SOURCE • Select a source: iPod/iPhone, FM tuner or MP3 link. VOL +/- • Adjust volume. Adjuster • Adjust the mechanism to ﬁt different iPod/iPhone. iPod/iPhone dock • Load an iPod/iPhone. /PRESET +/- • Skip to the previous/next audio ﬁle.
Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No.
Prepare the AC power adaptor. Connect one end of the AC adaptor to the DC IN socket on the main unit. Connect the other end of the AC adaptor to the wall outlet. Set time and date In standby mode, press and hold TIME SET/AUTO SCAN for 2 seconds.
Turn on Press POWER. » The unit switches to the last selected source. Switch to standby Press POWER again to switch the unit to standby mode. » The time and date (if set) appear on the display panel. • After being idled for 15 minutes in standby mode, the screen turns dim automatically.
Load the iPod/iPhone Place the iPod/iPhone in the dock. Turn the adjuster to ﬁt the iPod/iPhone.
Remove the iPod/iPhone Pull the iPod/iPhone out of the dock. Listen to the iPod/iPhone Ensure that the iPod/iPhone is loaded correctly. Press SOURCE repeatedly to select iPod/iPhone source. » The connected iPod/iPhone plays automatically. • To pause/resume play, press • To skip to a track, press •...
Listen to radio Note • Only FM radio reception is available on this unit. Tune to a radio station • Position the antenna as far as possible from TV, VCR or other radiation source. • For optimal reception, fully extend and adjust the position of the antenna.
Program radio stations automatically You can program a maximum of 20 preset radio stations. In the tuner mode, press and hold TIME SET/AUTO SCAN for more than 2 seconds to activate automatic program mode. » [AUTO] (auto) is displayed and begins to blink. »...
Other features Set the alarm timer You can set two alarms which go off at different time. Ensure that you have set the clock correctly. Press and hold ALM 1 or ALM 2 for 2 seconds. » Press TUNING +/- repeatedly to set the hour. Press ALM 1 or ALM 2 to conﬁrm.
• You can press TUNING+/- to adjust interval to repeat alarm. Stop alarm ring When the alarm rings, press the corresponding ALM 1 or ALM » The alarm stops but the alarm settings remain. View the alarm settings Press ALM 1 or ALM 2. Set the sleep timer This unit can switch to standby automatically after a set period of time.
Adjust display brightness Press BRIGHTNESS CONTROL repeatedly to select different levels of display brightness. Product information Note • Product information is subject to change without prior notice. Speciﬁcations Ampliﬁer Rated Output Power Frequency Response Signal to Noise Ratio MP3 link Tuner Tuning Range Tuning grid...
To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When <28 dBu <3% >45 dB...
Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power • Ensure that the AC power plug of the unit is connected properly. • Ensure that there is power at the AC outlet.
© Royal Philips Electronics N.V. 2009 All rights reserved. Speciﬁcations are subject to change without notice.Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. Printed in China DC315_05_UM_V2.0...