TP-Link TL-WR741ND Quick Installation Manual page 3

2. How do I restore my Router's configuration to its factory default settings?
With the Router powered on,
press and hold the Reset button
on the rear panel for 8 to 10
seconds before releasing it.
Press it for 8 to 10 seconds
Once the Router is reset, the current configuration settings will be lost and you
Note
will need to re-configure the router.
3. What can I do if I cannot access the Internet?
1) Check to see if all the connectors are connected well, including the telephone
line (for your modem), Ethernet cables and power adapter.
2) Make sure that you are connected to the TP-LINK Router with the computer
that was originally connected to your modem, then log on to the web-based
management page and browse to "Network > MAC Clone", click "Clone
MAC address" and then click "Save". Reboot the Router and try to access the
Internet from your computer, if the problem persists, please go to the next
step.
3) Log on to the web-based management page and browse to "Network >
LAN", change the default LAN IP address from 192.168.1.1 to 192.168.x.1 (x
can be any number from 2 to 254) to avoid an IP conflict with your Modem,
click the "Save" button; The Router will then reboot and you may try to
access the Internet from your computer. Please note that the Router can only
be accessed using the new LAN IP address (192.168.x.1).
4) Please feel free to contact our Technical Support if the problem persists.
2