Kenwood KIV-700 Service Manual page 10

KIV-700/BT900
■ Information display while all the lights are turned on
The following information shall be displayed when the key listed in the next table is pressed while all the lights are turned on in
STANDBY source.
[DISP]
∗ Press this key briefl y
or
[1]~[2]
(Remote controller)
[MENU]
∗ Press this key briefl y
[ ]
∗ Press this key briefl y
[ ]
[FAV]
∗ Press this key briefl y
[SEARCH MODE]
∗ Press this key briefl y
10
Press this key briefl y: To transfer to Software version & various service information display mode.
When [DISP] key is pressed briefl y, the following items are displayed alternately (toggled) as shown hereunder.
∗ When [DISP] key is pressed briefl y, the display is switched successively in the following sequence:
"Version display" → "POWER ON time display" → "All lights ON display" → "Version display".
∗ Remote controller [1]~[2] key When the key is pressed briefl y,
the display can be switched directly to the item for that key.
• Item
System μ-com software version, SoC μ-com software version,
Destination setting, ROM correction version, and Serial No. displays
↓
POWER ON time display
∗ Refer to "Attached table 1" for details.
Press this key briefl y: To call MENU LIST (Same operation as normal operation (i.e., operation defi ned in the product
specifi cation))
Press this key briefl y: To initialize AUDIO data
• Image of display
A U D I O _ I N I T
Press this key briefl y: To display Forced POWER OFF information
Press and hold this key: To clear Forced POWER OFF information. (Press this key and hold it for 2 seconds while
Forced POWER OFF information is displayed.)
• Image of display
(No Forced POWER OFF)
P O F F _ – – –
S E C (Forced POWER OFF because Security Code is not yet written)
P N L
(Forced POWER OFF because of communication error between system μ-com and panel)
Press this key briefl y: To display iPod authentication IC installation condition.
• Image of display
i P o d _ O K _ (Installation condition OK)
NG
(Installation condition NG)
Press this key briefl y: To change illumination color
• Variable illumination model
The color is switched in the next sequence: White (R255/G255/B255) → Red (R255/G0/B0) → Green (R0/G255/B0)
→ Blue (R0/G0/B255) → ...
TEST MODE
[1]
[DISP]
Press this key briefl y to toggle the
display item
∗ All lights ON display shall be in-
cluded among the displays that
are displayed.
[2]