Philips HTS3569 User Manual page 40

[ Picture Setting ]
Select a predefi ned set of picture colour
settings or customise your personal setting.
• [ Standard ] – original colour setting.
• [ Bright ] – vibrant colour setting.
• [ Soft ] – warm colour setting.
• [ Personal ] – customise the colour
setting. Set the level of brightness,
contrast, tint and colour saturation in
the menu, then press OK.
[ HDMI Setup ]
When you connect this unit and TV with
HDMI cable, select the best HDMI setup
that your TV can support.
• [ Wide Screen Format ] – defi ne the
wide screen format for disc play.
Options
[ Superwide ]
[ 4:3 Pillar
Box ]
[ Off ]
Note
•
This setting is only available if you have set the
[ TV Display ] setting to [ 16:9 Wide Screen ].
EN
40
1_hts3565-69_98_eng5_Final808.in40 40 1_hts3565-69_98_eng5_Final808.in40 40
Descriptions
Centre position of the
screen is stretched less
than the side. This
setting is only applicable
if the video resolution is
set to 720p or 1080i/p.
No stretching of the
picture. Black bars is
displayed on both sides
of the screen.
Picture will be displayed
according to the format
of the disc.
• [ HDMI Video ] – select a video
resolution that is compatible with your
TV display capability.
Options Descriptions
[ Auto ]
It detects and selects the
best supported video
resolution automatically.
[ 480p, 576p, Select a video resolution
720p, 1080i, that best supported by
1080p ] your TV. See your TVs
manual for details.
Note
•
If the setting is not compatible with your TV, a
blank screen appears. Wait for 15 seconds for auto
recover or switch to its default mode as follows:
1) Press Z. 2) Press b. 3) Press ZOOM.
• [ EasyLink ] – enable all the HDMI CEC
compliant TV/device response or react
to certain commands simultaneously
with one touch control.
Options Descriptions
[ Auto
It wake-ups your TV
Wake-up TV ]
automatically when you
press PLAY to power up
this unit and start disc
play (if a video disc is
found in the disc
compartment).
• To disable this feature,
select [ Off ]
[ System Respond to standby
Standby ] command from other
HDMI CEC compliant
TV/devices.
• To disable this feature,
select [ Decline ].
.
2008-02-19 3:42:12 PM 2008-02-19 3:42:12 PM