HKTS 10 harman/kardon SUB-TS10 150W Powered Amplifier LINE VOLTAGE Yes/No Hi/Lo Line Unit Notes US 120vac/60Hz 108-132 Vrms Normal Operation Parameter Specification Unit QA Test Limits Conditions Notes Amp Section Type (Class AB, D, other) Load Impedance (speaker) 4 Ohms...
NORMAL REVERSE AUTO IMPORTANT: CONNECT STRIPED WIRE TO RED ( ) SPEAKER TERMINAL. SUB-TS10 For use with ¡ Speaker-Level Inputs HKTS 10 System harman/kardon ™ Speaker-Level Outputs POWER £ Line-Level Subwoofer (SUB) Input Made in China ¢ Line-Level Full-Range Inputs ⁄...
Page 5
SUB- input accepts a remote control signal from TS10. The cord should not be plugged into a compatible Harman Kardon A/V receiver the accessory outlets found on some audio that enables you to override the High-Cut...
Page 6
HKTS 10 harman/kardon SPEAKER CONNECTIONS (continued) Dolby Digital or DTS (or other Center Front Front – Digital Surround Mode) Left Right – – Connection USE THIS INSTALLATION METHOD FOR DOLBY DIGITAL, DTS OR OTHER DIGITAL SURROUND PROCESSORS: Use the line-level input jack marked SUB...
Page 7
HKTS 10 harman/kardon SPEAKER CONNECTIONS (continued) Dolby Pro Logic Center Front Front – (Non-Digital) – Line Level Left Right – – USE THIS INSTALLATION METHOD FOR SUB-TS10 DOLBY PRO LOGIC APPLICATIONS (NOT Subwoofer DOLBY DIGITAL, DTS OR OTHER DIGITAL Line-Level...
Page 8
HKTS 10 harman/kardon SPEAKER CONNECTIONS (continued) Dolby Pro Logic* Center (Non-Digital) – Speaker Level – Front Left Front Right – – USE THIS INSTALLATION METHOD FOR DOLBY PRO LOGIC APPLICATIONS (NOT DOLBY DIGITAL, DTS OR OTHER DIGITAL PROCESSING), WHERE THE RECEIVER/...
HKTS 10 harman/kardon OPERATION Move the Master Power Switch ⁄ When your receiver or amplifier is off, or is When the Music-Sense On/Off Switch ¶ is switched to the ON position, the sub- • (marked Power) to the “ ” (On) position.
HKTS 10 harman/kardon TROUBLESHOOTING TROUBLESHOOTING If there is no sound from any of the If there is no sound from the center If there is no sound from the sur- speakers: speaker: round speakers: • Check that receiver/amplifier is on and a •...
GREEN: ON RED: STAND-BY PHASE NORMAL REVERSE AUTO IMPORTANT: CONNECT STRIPED WIRE TO RED ( ) SPEAKER TERMINAL. SUB-TS10 For use with HKTS 10 System AMPLIFIER harman/kardon POWER Made in China AC 120V~60Hz CAUTION CAUTION RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK...