Switch On/Off And Introduction - Raymarine ST70 Pilot Operating Manual

1
Card
S w i t c h i n g o n y o u r S T 7 0 P i l o t
To switch on your ST70 pilot, hold down
The pilot powers up and shows the page that was displayed
when the power was last switched off.
Note:
If power to a system to which ST70 pilot or instrument is connected is switched
centrally (e.g.from a central circuit breaker), the on/off condition of each individual in-
strument or pilot when system power is applied reverts to what it was when the system
power was last switched off. See the ST70 Autopilot Controller User Reference Guide
for system power protocol.
I m p o r t a n t
Do not use the pilot until it has been commissioned as
described in the ST70 Autopilot Controller / SmartPilot X Com-
missioning Instructions.
If you power up and a CHOOSE LANGUAGE page is displayed,
the pilot has not been commissioned since it was installed, so
you need to carry out the commissioning procedure before
using the pilot.
S w i t c h i n g o f f a n S T 7 0 P i l o t w h e n i n
S t a n d b y
You can only switch off your pilot when in Standby mode.
If you are in Auto mode, press
To switch off your ST70 pilot, hold down
then continue to hold down
• The display goes blank.
• The pilot power down is complete.
S w i t c h o n / o f f & i n t r o d u c t i o n
for 1 second.
STANDBY
to go to Standby mode.
STANDBY
for 1 second, to display the count-down popup,
STANDBY
until the display counter reaches zero. At that point:
STANDBY
S T 7 0 p i l o t - g e t t i n g s t a r t e d
N
19.1
TWS KTS
W E
6.2
Depth M
S
14.8
M
SOG KTS
DODGE TRACK
--1 + 1
MENU
--10 + 10
STANDBY AUTO
CANCEL ENTER
Language
English (UK)
Press ENTER to select
DODGE TRACK
+ 1
--1
MENU
+ 10
--10
STANDBY AUTO
CANCEL ENTER
continued ...