Polaris Sportsman 400 Lift Installation Instructions Manual page 5

Rear Lift
1) Place jack under the center of the ATV, just forward of where the rear drive shaft connects to the
engine, and lift until the weight is off the suspension. Be careful to secure the ATV properly so it is
stable on the jack.
2) Remove the rear wheels.
3) Disconnect the lower shock and sway bar arm from the control arm of the ATV.
4) Place the large space between the shock mount tabs on the control arm.
5) Now connect the rear lift brackets to the shock mount on the control arm by using a 3/8 x 3" bolt
and 3/8 lock nut. Connect the brackets according to photo display.
6) Connect the bottom of the shock to the brackets. Also place the large support bracket between the
shock and the sway bar arm.
NOTE: Make sure that the notch on the bracket is facing downward
5