Removal of Operation LED C.B.A. from Bottom Cover.
a. Releasing the tab and 2 ribs, and remove the Operation
LED C.B.A.
Fig. C6
4. Installation of Mechanism Chassis onto Main C.B.A.
a. Make sure the Mode Select SW. on the Main C.B.A. is
in EJECT position. If not, rotate the Mode Select SW.
until the alignment projection is in the EJECT Position.
Fig. C7
b. Make sure the phase hole of the Main Cam Gear on the
bottom side of Mechanism Unit is in EJECT position.
c. Install the Mechanism Chassis straight onto the Main
C.B.A. so that the Photo transistor Unit (712) clears the
hole in the Mechanism Chassis and that 3 Connectors
(P5001, P4001, P6201) are aligned and seated
securely.
5.2.
MECHANISM SECTION
Refer to the Service Manual for R4-Mechanism Chassis for PV-
Model (Order No. MKE0401000C1).
21
PV-D4735S / PV-D4745 / PV-D4745S / PV-D4745S-K
Fig. C8