Table of Contents
Advertisement
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR
HEADSET)
Note:
◆ The transceiver is not fully water resistant when using a speaker/ microphone or
headset.
1 Insert the speaker/ microphone (or headset) plugs into
the speaker/ microphone jacks of the transceiver.
2 Place the locking bracket over the speaker/ microphone
(or headset) plugs so that the locking tabs insert into the
transceiver grooves.
•
Push down on the locking bracket to slide it into
place.
3 While holding the locking bracket in place, push it
towards the bottom of the transceiver until the tabs on
the bracket click into place.
•
To remove the locking bracket, push the bracket up
from the base.
7
Advertisement
Table of Contents
