Samsung DCS-VIP User Manual page 54

− Off(100ms) : Set the duration between one ring and another.
SMDR Option SMDR Option
SMDR Option SMDR Option
On this screen, you can select which SMDR (System Message Detail Recording)
options should be printed.
To print the required information tick the relevant
button. Each parameter is as follows.
Page Header : Output title or header for each page.
!
Line Per Page : The numbers of line on each page. (99 lines max.)
!
Incoming Call : Output incoming calls.
!
Outgoing Call : Output outgoing calls.
!
Authorized Code : Output level change code
!
Less Start Time : Output calls that ended before SMDR was activated.
!
In/Out Group : Output in/out group messages.
!
DND Call : Output Do Not Disturb calls.
!
Wake Up Call : Output station alarms.
!
Directory Name : Company name that will be printed out with the header.
!
CLIP Data : Output information about callers : SMDR (16 digits max.)
!
Abandon Call : Output information about abandoned trunk calls.
!
No.of Dial Mask 0 : The number of digits that will not be printed out (18 digits
!
max.)
Incoming Answer : Answered incoming calls.
!
System Counters System Counters System Counters System Counters
On the System Counters screen, you can reset system counters.
Set the following parameter values and click the Set button. You can use numbers
01 ~ 99.
Alarm Reminder : Enter the number of times to ring an alarm.
!
Auto Redial : Enter the number of times to redial.
!
New Call : Enter the number of times a trunk may be reused.
!
System I/O System I/O System I/O System I/O
On the System I/O screen, you can set the parameters for the system input /output
mode.
First, click the Service Type dropdown button and choose the equipment to be
connected to the system input/output port. Then, select the following parameter
values and click the Set button.
Service Type : Select the service type.
!
Baud Rate : Set the transmitting speed.
!
Char Len : Set the character length.
!
Parity : Set the parity.
!
Retry Count : Enter the number of times to retry.
!
Stop Bit : Set the stop bit.
!
Wait Time : Set the message wait time.
!
Pwr Check : Select whether to check password or not.
!
System Timers System Timers System Timers System Timers
On the System Timers screen, you can reset the system timers.
DCS-VIP User Guide
parameter(s)
54
and click the Set