Placing The Dislodged Leader Pin Into The; Rewinding The Tape Into The Cartridge - IBM TS3500 Introduction And Planning Manual

1. Slide open the cartridge door ( 1 in Figure 42) and locate the leader pin 2 .
2. With plastic or blunt-end tweezers, grasp the leader pin and position it in the
3. Press the leader pin gently into the clips until it snaps into place and is firmly
4. Close the cartridge door.
Figure 42. Placing the dislodged leader pin into the correct position. The cartridge door is open to show the leader pin.
5. To rewind the tape, insert the cartridge manual rewind tool ( 1 in Figure 43)
Figure 43. Rewinding the tape into the cartridge
6. Remove the rewind tool.
You may need to shake the cartridge gently to roll the pin toward the door.
pin-retaining spring clips 3 .
seated. Ensure that there are no gaps in the seam of the cartridge 4 .
Note: If gaps exist, do not continue with this procedure and do not use the
cartridge. Instead, contact your IBM service representative.
into the cartridge's hub 2 and turn it clockwise until the tape becomes taut.
Chapter 4. Using Ultrium media
161