Leader Pin In The Incorrect And Correct; Placing The Dislodged Leader Pin Into The - IBM Ultrium Gen 6 Installation And User Manual

incorrect and correct positions.
Figure 13. Leader pin in the incorrect and correct positions. The cartridge door is open and
the leader pin is visible inside the cartridge.
70
IBM Half High LTO Ultrium Gen 6 Internal SAS Tape Drive: Installation and User's Guide
To reposition the leader pin, see "Repositioning a leader pin" on page 69 and complete the
following steps:
1. Slide open the cartridge door and locate the leader pin.
Note: If necessary, shake the cartridge gently to roll the pin toward the door.
2. With plastic or blunt-end tweezers, grasp the leader pin and position it in the
pin-retaining spring clips.
3. Press the leader pin gently into the clips until it snaps into place and is firmly seated.
4. Close the cartridge door.
5. Make sure that there are no gaps in the seam of the cartridge
Figure 14. Placing the dislodged leader pin into the correct position