Wiring Dc Power Inputs - Planet IGSW-24040T Quick Installation Manual

3. Wiring DC Power Inputs

The 6-contact terminal block connector on the rear panel of IGSW-24040T is used
for two DC redundant powers input. Please follow the steps below to insert the
power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for DC
POWER 1, or 5 and 6 for DC POWER 2.
CAUTION
Please refer to user's manual before
connect the DC wire.
DC Input Range: 36V~72V DC
2. Tighten the wire-clamp screws for preventing the wires from loosing.
The wire gauge for the terminal block should be in the range
between 12 ~ 24 AWG.
Note
4
DI 0 DI 1 DO 0 DO 1 GND N/A
DC 1 Fault DC 2
1 2 3
DC 1
Fault Alarm
+ -
AC POWER
100~240V AC
ON
50/60Hz
OFF
4 5 6
DC 2
+ -