Hardware - Sony Ericsson Z530c Installation Instruction

2.2

Hardware

2.2.1 Computer (SERP Only)
Ensure the computer (POS-96) is installed and configured correctly according to the instructions
supplied by the manufacturer.
2.2.2 Test Instrument
The test instrument (POS-76) used must be a Sony Ericsson approved instrument with all
required software and hardware options installed. Refer to the Z530 Equipment List, Electrical
for the list of approved test instruments.
The test instrument installation and operation should be in accordance with the manufacturer's
instructions.
2.2.3 GPIB Card and Cable (SERP Only)
1. Install the GPIB card (POS-83) in the computer according to the instructions supplied by the
manufacturer.
2. Use the GPIB cable (POS-84) to connect the GPIB card (POS-83) to the test instrument
(POS-76).
2.2.4 RF Cable
1. Connect the RF Cable's (POS-51) N-type connector to the RF port of the Test Instrument
(POS-76).
2.2.5 RF Probe Assembly (Conducted Test Method)
1. Connect the RF Probe Assembly (POS-62) to the RF cable's (POS-51) SMA type connector.
2.2.6 Battery Eliminator, Jumper cables and Power Supply (optional)
Refer to Section 4 of this document for installation instructions for the Power Supply.
NOTE!
2.2.7 RF Shield Box (Radiated Test Method)
1. Connect the RF adapter (POS-110) to the RF shield box (POS-91).
2. Connect the RF cable's (POS-51) SMA type connector to the RF adapter (POS-110).
1/000 21-2/FEA 209 544/103 A
©
Sony Ericsson Mobile Communications AB
It is preferred that a standard fully charged battery be used to power the phone
during the GNG test. However, a second option is to use the Battery Eliminator
(Dummy Battery) with a power supply that meets the requirements documented in
the Electrical Equipment List.
Installation Instruction, Electrical
3(9)