Related Manuals for MSI MS-1035
Summary of Contents for MSI MS-1035
-
Page 1: Table Of Contents
Step 4: Installing Mini PCI WLAN Card p. 6 Step 5: Installing Notebook Hard Drive (HDD) p. 7 Step 6: Installing the Battery p. 9 Step 7: Final Check p. 10 Step 8: Entering BIOS p. 11 Installation Guide Copyright®2006 MSI Computer Corp. -
Page 2: Overview
Overview Open View Bottom View MS-1035 is shipped out as a bare bone. Some of the components are 1. CPU Compartment 1. Cover latch 2. Mini PCI Drive Compartment equipped while some are not. This installation guide provides you with the 2. -
Page 3: Step 1: Installing Cpu
Step 1 : Installing CPU 2-2 Slide the CPU Heat Sink and Fan assembly over the CPU !! Be sure that there are no wires underneath the Heat Sink !! 1-1 Prepare a proper size flat head screw driver. Un-screw the screw until it can not go any further 2-3 a.b.c.d. -
Page 4: Step 3: Installing Notebook Memory
Step 3 : Installing Notebook Memory Step 4 : Installing Mini PCI WLAN Card 3-1 Align the memory module to the DIMM socket 1. !! Memory module can only fit in 4-1 Align the Mini PCI Card to the Mini PCI socket. one direction due to the keyed notch. -
Page 5: Step 5: Installing Notebook Hard Drive (Hdd)
4-5 a.b.c.d.e. After installing the CPU, Memory, and Mini PCI Card, gently slide the 5-2 a.b. Insert the HDD into the given HDD shielding tray. !! Make sure that the screw cover until it locks into position. Lock down the cover by spplying 4 screws. holes to attachHDD to Notebook are on the opposite side of the HDD Pins !! Improper aligment will cause damage to the HDD and the Notebook !! 5-3 a.b.c.d. -
Page 6: Step 6: Installing The Battery
5-5 a.b. Push HDD down into the HDD Bay. Tighten the two screws that are provided Step 6 : Installing the Battery to secure the HDD in place. !! Failure to apply 2 screws may cause HDD assembly 6-1 a.b.c. Align battery to the battery slot and push down the battery gently. to fall off in Notebook HDD area and will damage the HDD and Notebook !! Hint: If you wish to remove the battery, make sure the battery locking mechanism is in “Unlock”... -
Page 7: Step 8: Entering Bios
Step 8 : Entering BIOS 8-3 Insert a Bootable OS CD into the OSD tray. 8-4 To save/exit the BIOS Setup Screen, go under the “Exit” menu press <Enter> Before powering on the notebook, plug in notebook power adapter into the notebook. under “Save Changes and Exit.”...