Table of Contents
Advertisement
Caveats
Table 26
DDTs Issue
CSCdw74792
CSCdw88500
CSCdw92493
CSCdx02665
CSCdx02968
CSCdx06502
CSCdx07103
CSCdx12589
CSCdx17703
CSCdx21223
CSCdx25180
CSCdx46551
CSCdx48591
CSCdx49437
CSCdx52205
CSCdx53377
CSCdx53588
CSCdx56381
CSCdx57063
CSCdx57276
CSCdx65568
CSCdx67473
CSCdx71649
CSCdx72931
CSCdx74295
CSCdx76563
CSCdx77741
CSCdx77992
CSCdx81229
CSCdx81929
CSCdx82320
CSCdx82867
CSCdx83697
CSCdx86090
CSCdx94150
CSCdx94710
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
68
Resolved Caveats for MGX 8830 3.0.10 Software (continued)
Description
JANPN:Cant stop dspchancnt display using ctrl-c
dspred shows inconsistent Card Type for SRM slot
PXM1E loses traffic with FRSM8T1 and FRSM2T3 insta.
Connection counts displayed with dspport are incorr
When single pxm1e is used, only 1 slot of srm shou
PXM1E:Incorret error message for addred when card
cannot change ds3 lines to e3 in combo cd when all.
Wrong Code Can Run In MGX8830 Without Warning
RDI from ATM network by SIW con is not mapped into.
NNI link goes into auto config state after switchc.
PXM1E DevTest: SSCOP PDUs corrupted in stable link
dspapsbkplane command only applicable to pxm1e wit.
REG3.0: SSCOP PDU corruption causes conns. to be u.
cnfcon caused false error logged on PXM1E
CESM not allowed to come on-line due to clock issu.
frsm/ausm go unreserved after switchcc .
VISM Releases Active calls on PXM1E SWOVER.
SM 0 byte card file.
SPVC failed to route after service modules were re.
REG3.0: Ln not up after power cycle.
pxm1e switchover took 15 seconds after removal of .
restoreallncf aborts if current SW version differe
CESM pnports down on PXM1E but ports active on CES.
Enabling Drivers take 1.6 seconds during switchcc .
PXM1E node shows active/standby with two different.
dspcons/dspchans results in response Getting Filte.
dsppnport shows some sm ports as down when they ar.
PXM1E:primary clk get unlockable if u remove and i
dspcons from pxm1e show failed, but SM show them a.
lsmProxy support for vism on pxm1e.
secondary SM not taking over if primary SM is out.
dspcd does not display CLEI codes for some SMs
OAM task taking 20% CPU
receiving pnni complex node messages after switchc.
Memory corruption on FRSM - indicate no channel av.
REG3.0: PXM1E: Remove 4 port OC3 backcard, outage.
OL-2914-01 Rev D0, July 3, 2003
Advertisement
Table of Contents
