Replacing The Needle Bar, Needle Spring And Cushion - ELNA 9900 Service Manual

Replacing the Needle Bar, Needle Spring and Cushion

1. Remove the presser foot (see pages 16 and
Needle bar
2. Loosen the needle bar holder screw.
Needle bar spring
3. Pull the needle bar up and out of the frame.
Needle bar holder
4. Insert the needle bar down into the frame and
Needle bar
holder screw
Spring base
5. Attach the presser foot.
Presser foot
spring (lower)
6. Adjust the needle height (see page 25).
Presser foot block
7. Adjust the presser bar height (see pages 16
Stop felt
Presser foot
holder
Presser foot
return spring
Washer
26
17).
To remove the parts on the needle bar, pull the
needle bar as far as the desired part can be
removed.
put the parts on the needle bar as it goes.
and 17).
elna 9900