Sleep Mode; Interface Selection - Argox AI-6821 Quick Start Manual

(*) Default
Option Description
Turn on Align
On
mode.
Turn off Align
*Off
mode.
Connect to your cradle again
If your scanner has connected to other device,
and you want it to connect to your cradle
again, do this:
1. Scan the following bar code.
Option Description
Connect your
SPP/COM scanner back to
your cradle.
2. Scan the Data Matrix code at the bottom
of your cradle.

Sleep mode

To save battery power, you can put your
scanner into sleep if it doesn't work in a
certain amount of time. To wake it up, just
pull the trigger. Note that your scanner needs
2-3 seconds to wake up, since the engine
needs a little time to start.
Bar Code
Bar Code
3
(*) Default
Option Description
Turn off Sleep
*0
mode.
Go to sleep after
1 being idle for 10
minutes.
Go to sleep after
3 being idle for 30
minutes.
Go to sleep after
6 being idle for 60
minutes.
Go to sleep after
9 being idle for 90
minutes.

Interface selection

AI-6821 supports RS-232, USB HID and virtual
COM. By default, your cradle is able to detect
the interface automatically. When it detects
USB, it selects HID as your scanner's interface.
(*) Default
Option Description
1 RS-232
Bar Code
Bar Code
4