Sony CDX-S2010 Service Manual page 18

CDX-S2010/S2010C/S2010T/S2010X/S2050EE
Ver. 1.3
• NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1 / W or less unless otherwise
4
specified.
• : internal component.
f
• C : panel designation.
Note: Note:
The components identi- Les composants identifiés par
fied by mark 0 or dotted une marque 0 sont critiques
line with mark 0 are criti- pour la sécurité.
Ne les remplacer que par une
cal for safety.
piéce portant le numéro
Replace only with part
spécifié.
number specified.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• CD mechanism section
no mark : CD PLAY
• Main (1/2), (2/2) and Display sections
no mark : FM
( ) : AM
< > : CD PLAY
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY
F
: FM
f
: AM
CDX-S2010/S2010C/S2010T/S2010X/S2050EE
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Through hole.
a
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
C
Q
These are omitted
B E
B E C
These are omitted
E C B
These are omitted
• Waveforms
— MAIN Board —
1
IC501 i; (XOUT)
32.678kHz
2
IC501 id (OSC IN)
18.432MHz
18 18
— SERVO Board —
1
IC1 wd (XTAL)
1.4Vp-p
16.9344MHz
2
IC1 uj (AGCI)
1.2Vp-p
3
IC1 od (FEO)
Approx. 620mVp-p
4
IC1 oh (TEO)
Approx. 200mVp-p
1.2Vp-p
0.85V to
1.45Vp-p
0V
0V