Iap2 Protocol Settings - Epson TM-T88V Technical Reference Manual

iAP2 Protocol Settings

When the firmware version for interface board is 1.05 or later, you can change the accessory protocol (iAP2)
settings used to connect with the device.
Follow the steps below.
1
Load the roll paper.
2
Close the roll paper cover.
3
Turn on the printer while holding down the interface board push button. (Do not
release the push button until printing starts.)
The printer starts printing Wireless Module Setup instructions.
4
Briefly press the push button twice.
5
Press the push button again. (Do not release the push button until printing starts.)
The printer starts printing Bluetooth Setting instructions.
6
Briefly press the push button twice.
The printer starts printing (iAP2) instructions.
Setting
Enable (default)
Disable
14
iAP2 is used to connect to the device. This setting should normally be used.
iAP1 is used to connect to the device. Use when there is a problem connecting
to the device using iAP2.
Explanation