Programming And Operations Information - Panasonic PS-2000ST Operating Instructions Manual

Programming and Operations Information
General Information
The PS-2000ST is designed for automatic operation and simplified installation.
Pre-stored in the memory are the names, relative locations, format and frequency band of over 40 satellites with pro
visions for storing about 20 new satellites when they are launched into orbit.
The set-up mode is accomplished using the remote control with no programming controls located on the front panel of
the receiver. After set up operation, it is extremely simple to change various settings from the remote control without
resorting to the set-up mode. AFC ON or OFF, video fine tune, Tl filter ON or OFF, audio bandwidth, antenna fine po
sitioning may all be changed from the remote control and are automatically stored in memory on a per-channel basis
after adjustment.
Satellite selection, channel selection, and audio tuning may be done either by direct access using the 10 number but
tons, or by using the appropriate slew controls.
On-Screen Displays
The PS^2000ST generates a variety of on-screen informational displays.
Programming in set-up mode and operations in auto mode are carried out sequentially as the on-screen display indicates.
This Operating Instructions Illustrate the on-screen display in each step of operation.
However these illustrations may be different depending on your setting and selection.
A full data display indicates the current satellite, channel, polarity, antenna position, and more.
You can also check your setting at any time by pressing the I DISPLAVl button on the remote control.
When the equipment is turned on and the I DISPLAVl button on the remote control is depressed, the following data
will be displayed on TV or the monitor screen connected to the equipment.
MUTE
CH13
GALAXY
CBAND
AFC
POSITION
VC2. AUDIO
NARROW
AUDIO
SIGNAL
A 5.76
VER 1.00
Software Version
(for Service use)
In the set-up mode, "SET UP" is displayed.
Z2 Displays name of pre-stored satellite.
In the set-up mode, "SKEW" is displayed when adjusting skew.
On-Screen Display with Satellite Graphics
This on-screen display is shown during the time the
antenna is slewing from one satellite to another.
No. PARAMETER DATA INPUT CHOICES
Channel Channel number
(2) AFC ON/OFF
"AFC" or no display
Audio Mode
"MONO" or"VC2 AUDIO"
®
Audio
Subcarrier
A: 5:00 ~ 8.60 MHz
Signal Strength
0-50
® Satellite
Satellite name
@
Mute
"MUTE" or no display
®
Satellite
Name & No.
Name letter
No 1 ~9
Tl Filter ON/OFF
"Tl" or no display
Antenna
Position
0000 - 9999
V/H Select
"VERT" or "HOR"
©
Audio Bandwidth
"WIDE" or "NARROW"
<Example>
SATCOM F1
AFC Tl
W
CH24
C BAND
- 12-