Bios Error Messages - Fujitsu PG-126 User Manual

4.2 BIOS Error Messages

If Host Adapter BIOS is enabled, but cannot be initialized, the system displays an
error message after the message "BIOS Installation Failure." Examples and
meanings of these error messages are given below:
Device connected, but not ready.
This message is displayed if this card does not receive a response when this card
requests data from an installed SCSI device. Try setting the ｢Send Start Unit
Command｣ of the SCSISelect utility to ｢yes｣.
If the message is still displayed, follow the disk drive manufacturer's instructions and
set the drive to rotate when the power switch is ON.
Start unit request failed.
BIOS cannot send a Start Unit command to a device. Run the SCSISelect utility and
E
｢no｣ ｢Send Start Unit Command｣ for that device.
Time-out failure during ....
An unexpected time-out occurred. Check the SCSI bus termination. Disconnect the
SCSI cable from this card and start the SERVER. If the SERVER restarts without
any problem, check that the SCSI bus terminator and cables are properly connected.
One of the devices or cables on the SCSI bus might be the cause of the failure.
19