Whirlpool W10856086A Use & Care Manual page 12

11.
Select any additional options
After setting temperature or spin speed, the light above
"Options" lights up. Turn the knob to select the desired
option(s). As you turn the knob, the option symbols above the
Options button will light up one at a time as you turn the knob.
Stop turning when the symbol of the desired option lights up.
Press the knob to confirm your selection.
12.
Touch Start/Pause button to begin
wash program/cycle
Touch the Start/Pause button to start the wash program/cycle.
To pause a program/cycle in progress, touch the Start/Pause
button once, then touch again to continue the program/cycle.
To cancel a program/cycle, touch the Power button.
Once you touch the Start/Pause button, you will hear the door
lock. The washer door will remain locked during the wash
program/cycle.
12
†
Options
3 Sec
ml
X-hot Max
Hot High
Warm Med
Cool Low
Cold O
Colors Rinse
Hold
13.
Touch Power button to turn off
washer after program/cycle ends
14.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle
has completed to avoid odor and rusting of
metal objects on garments. When unloading
garments, pull back the door seal and check
for small items between the tub and the washer drum.
If you will be unable to remove the load
promptly, use the TumbleFresh
If the TumbleFresh option is selected, the
™
washer will automatically tumble the load
periodically for up to 6 hours. To turn off the
TumbleFresh option, touch the Power button.
™
To set the washer so that the TumbleFresh
option does not come on for future cycles,
touch the TumbleFresh button.
NOTE:
The door will remain locked while the TumbleFresh
n
is active. To cancel the option and unlock the door, touch
the Power button.
A small amount of water may remain in the dispensers after
n
the wash cycle is complete. This is normal.
This washer has a tight seal to avoid water leaks. To avoid
n
odors, leave the door open to allow the washer to dry
between uses.
Not all options and settings are available with all program/cycles.
†
See "Program/Cycle Guide" for available options and settings.
option.
™
™
option
™