Table of Contents
Advertisement
Be sure system power is off before plugging in or pulling out the CompactFlash
Caution
card.
Getting Started with the TPC-22xx
2.
Verify that the CompactFlash card containing Windows Embedded or
another operating system is installed in the unit.
3.
Connect the power connector to an 18–32 VDC power line. Be sure to
connect the positive, negative, and ground lines as shown in Figure 2.
The power lines can be from either a power adapter or in-house power
source.
4.
Connect the power connector to the power receptor on the TPC-22xx.
The power receptor pin assignment is shown in Figure 3.
Figure 3. Power Receptor and Pin Assignment
5.
The system powers on immediately after you apply power.
+ –
GND
Figure 2. Power Connector
– +
GND
4
ni.com
Advertisement
Table of Contents
