TABLE OF CONTENTS
1.
2.
................................................................... 3
3.
......................................................... 4
4.
TUNER Section .............................................................. 6
5.
5-4. IC Pin Function Description ........................................... 20
6.
EXPLODED VIEW
7.
ELECTRICAL PARTS LIST
............................................... 2
................................................... 21
............................... 22
SERVICING NOTES
Forced Reset
The system microprocessor can be reset in the following proce-
dure.
Use these procedure when the unit cannot be worked normally
due to the overrunning of the microprocessor, etc.
Procedure:
1. Set to radio OFF.
2. While pressing the
[START/STOP]
and
3. The unit is reset, and display blinking "
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
- 2 -
SECTION 1
[SCAN]
button, press two buttons of
[BAND]
simultaneously for 5 seconds.
12:00".
AM