Cookware That Is Suitable For An Induction Hob; Protection Against Accidental Operation Of The Hob - Smeg KF24.1 User Manual

o If a cooking zone is selected but no pan is detected, the pan
sensor system will check for the presence of a pan
approximately every 2 seconds.
o You should check that your pans are suitable for use on an
induction zone hob (see the pan manufacturer's trademark or
instructions).

Cookware that is suitable for an induction hob

The table below shows cookware that is normally suitable for use on
an induction zone hob:-
Cookware
Steel, enamelled steel
Cast iron
Stainless steel
Aluminium, copper, brass
Glass, ceramic, porcelain
o The bottom of the pans should be as flat and thick as possible.
o Certain types of cookware may result in a noise being made
when being used on an induction zone hob. This does not mean
that there is an appliance fault.
o IMPORTANT: You should make sure that all pans are placed in
the centre of the induction zone that you are using.

Protection against accidental operation of the hob

If when the hob is switched on, the electronic control senses a
continuous operation of any hob button for approximately 10 seconds,
it will switch the appliance off automatically.
o If this occurs, then there will be an audible signal that lasts for
10 seconds and "ER03" will appear on the display.
o If a pan or some other object has been accidentally placed onto
the control panel, then it should be removed.
Suitable
Yes (if stated by the pan
manufacturer)
17
Yes
Yes
No
No