Zanussi ZWF 1210 User Manual page 11

A tune sounds when the appliance is activated.
The appliance performs a start up animation.
The animation quickly shows each washing
programme and the default temperature and
spin settings.
Setting a programme
1. Touch the programme button
programme:
• The indicator of the button
slowly.
2. If necessary, change the temperature and
the spin speed or add available options.
When you activate an option, the indicator
of the set option comes on.
If you set something incorrect, the
indicator of the button
red three times.
Starting a programme without the delay
start
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks,
the indicator
The drain pump can operate for a
short time at the beginning of the
washing cycle.
Starting a programme with the delay
start
The start of the programme can be delayed by
9, 6 or 3 hours.
1. Touch the button
you want to set.
The indicator of the selected delay is on.
2. Touch the button
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the delay start before you touch the
button . After touching the
button you can only cancel the
delay.
www.zanussi.com
and set the
flashes
flashes
.
stops to
is on.
to choose the delay
:
To cancel the delay start:
1. Touch the button
to pause.
2. Touch the button
the set delay goes off.
Touch the button
programme immediately.
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options.
3. Touch again.
The programme continues.
Cancelling a programme
1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
The appliance does not drain the
water. The water left in a drum can
be used for the next washing cycle.
Opening the door
While a programme or the delay start operates,
the appliance door is locked. The indicator
is on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the door.
To open the door during the first minutes
of the cycle or when the delay start
operates:
1. Touch the button
appliance.
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
again. The programme (or the delay start)
continues.
to set the appliance
until the indicator of
again to start the
for some seconds to
to pause the
goes off.
11