Minelab x-terra 305 Instruction Manual page 40

Check the hole for the target. If it is not in
the hole, place the detector on the ground
with the coil flat, pick up a handful of soil
and pass it over the coil. Be sure not to wear
rings, bracelets or a watch which will produce
a signal. Repeat this procedure until the target
is located.
Ensure that no other targets remain, then refill
the hole. All soil and portions of grass on the
plastic sheet should be returned to the hole
as neatly as possible. Step lightly on the soil to
compact it.
Leaving holes, or a scarred area
may result in action being taken to
prevent the use of metal detectors.
Please ensure that you leave an
area of ground as it was found.
Try to take all rubbish.
39