Samsung SNH-V6430BNH User Manual page 10

installing on the wall and ceiling using screws
Take out the screws (M3xL20) and anchors (Φ5x25mm).
1.
when installing on a wooden wall
Fix the bracket to the wall using screws, as
2.
shown in the next image. Using a Phillips
screwdriver, fasten screws in 3 screw holes
on the wall on which the camera is to be
installed.
when installing on a concrete wall
Fix the bracket on the wall using screws and
2.
anchors. First, mark the wall on which the
camera is to be installed as shown in the
figure.
10 · English
On the mark, drill a hole to a depth of about
3.
3cm in the wall using a drill bit and drill with a
5mm diameter for concrete. Remove any
debris remaining in the hole after drilling.
Use caution when drilling to avoid injury.
`
J
Insert an anchor in each of the 3 holes for the
4.
screws, then hit the back of the anchor with a
hammer or a rubber mallet until it is
completely inserted.
Insert a screw in each of the 3 holes in the
5.
wall, and tighten the screws using a Phillips
screwdriver.
Connect the PoE adapter to the camera.
6.