Clarion NX405 Quick Start Manual & Installation Manual page 30

Installation Notes
WARNING
• Please note the position of pipes, tanks and electrical wirings before
installing the unit into the vehicle; failure in avoiding these may cause a
CAUTION
• Use only the supplied parts.
• Any holes made in the body of the vehicle should be sealed with a
silicon adhesive. If exhaust fumes or water penetrates into the vehicle,
this may cause an accident.
• Fasten the bolts securely when installing the unit. If the bolts are loose
an accident or malfunction could occur.
Connection Notes
WARNING
• Loom all cables according to the instruction manual, so as not to hinder
operation.
• Wire the connecting cords/cables away from high temperature areas.
short circuit. Take care when wiring in the engine compartment.
• When wiring the connecting cables in a vehicle with an airbag system,
of the airbag. An airbag not operating correctly in an emergency may
cause increased injury.
CAUTION
• Verify wires with a digital multi-meter prior to making any connections.
Many new vehicles use multiplexed and/or low voltage circuits that can
be damaged if a test light or logic probe is used.
• Connect cables appropriately. If a wrong connection is made, this may
• When passing cables through the body of the vehicle, use non-
conductive grommets. If the coatings of the cables are worn out by
cords to/from the unit, otherwise an electric shock, injury or accident
may occur.
NX405 29