Access The Web Manager; Configure The Switch - D-Link DIR-100 Quick Installation Manual

Access the Web Manager

To use your Web browser to access the web pages used to set up the Router,
your computer's IP settings must be configured be in the same subnet as the
VLAN Switch. The default IP address of the Switch is 192.168.0.1 with a subnet
mask of 255.255.255.0, therefore your computer needs an IP address in the
range 192.168.0.2 to 192.168.0.254.
NOTE: The wrong proxy server settings on your browser can
prevent connection to the web manager. If you are having trouble
connecting to the web interface of the Router, configure the proxy
settings to bypass the proxy server or disable use of proxy servers
and try to connect again.
Open your Web browser and type "http://192.168.0.1" into the URL address box. Then press the Enter or
Return key. The login dialog box appears.
Type admin for the User Name and leave the Password field blank.

Configure the Switch

The Web Manager used for configuration uses directories to organize the various menus used to configure and
monitor the VLAN Switch. The first page that appears after logging in presents the Device Management display
menu in the System menu directory.
4
Factory default settings:
IP Address: 192.168.0.1
Login User Name: admin (No
default login password) To reset
device to factory default settings:
1. Leave the device powered on,
do not disconnect the power.
2. Press the reset button and
hold (use a paper-clip). See
the back panel illustration
above to view the location of
the reset button.
3. Keep the button pressed
about 10 seconds.
4. Release the button.