Philips DVDR5350H/02 Service Manual page 64

EN 64 5.
3139 785 31532
Nucleus Name DS_SYS_DisplayFatalGet
Nucleus Number 1225
Description Get the display-fatal flag of the recorder
Technical -
Execution Time Less than 1 second.
User Input None
Error Number
122500
122501
122502
122503
122504
122505
122506
122507
122508
Example DS:> 1225
122500: The Display Fatal functionality is ON
Test OK @
Nucleus Name DS_SYS_SettingsSet
Nucleus Number 1226
Description Programs the digital board settings into the boot EEPROM on the digital board.
Technical -
-
-
-
Execution Time 1 second
User Input A large hexadecimal value that represents the digital board settings obtained
from the XDIVTOOL.exe program or from a reference set.
Error Number
122600
122601
122602
Example DS:> 1226 646961677473746201010200010101010101000020080000
122600:
Test OK @
Firmware Upgrading & Diagnostic Software
Issue the command to get the status of the display-fatal functionality to the
analogue board
Description
Getting the display-fatal flag succeeded
Getting the display-fatal flag failed
The returned errorcode from the analogue board is unknown:
No DS errCode known for analogue board error:
There was no response from the analogue board.
Reading the display fatal flag failed
Initialisation of IIC or reaching NVRAM failed
Unexpected version read from NVRAM section
Reading the fatal flag from NVRAM failed
Evaluate user input.
Set-up IIC-bus.
Write data to boot EEPROM.
Update checksum.
Description
The settings were successfully programmed.
User input is invalid.
IIC access failed.