Electrolux ENN28600 User Manual page 9

Problem
Water flows onto the
floor
The lamp does not work.
It is too warm in the re-
frigerator
It is too cold in the refrig-
erator
There is too much frost
and ice
It is too warm in the
freezer
It is too cold inside the
freezer
Possible cause
Products placed in can prevent
water from flowing into the col-
lector
The melting water outlet flows
not into the evaporative tray
above the compressor
The lamp is in stand-by.
The lamp is defective.
The Temperature Regulator may
be set incorrectly
The door does not close tightly
or it is not shut properly
Food placed in the appliance
was too warm
Large quantities of food to be
cooled were put in at the same
time
There is no inside cool air circu-
lation
The Temperature Regulator may
be set incorrectly
Products are not wrapped prop-
erly
Doors are not shut properly or
do not close tightly
The Temperature Regulator may
be set incorrectly
Temperature Regulator may be
set incorrectly
The door does not close tightly
or it is not shut properly
Large quantities of food to be
frozen were put in at the same
time
Food placed in the appliance
was too warm
Products to be frozen are
placed too closely to each other
Temperature Regulator may be
set incorrectly
Solution
Replace the products so that they
can not touch the back plate di-
rectly
Put the melting water outlet to the
evaporative tray
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean
Allow food to cool to room tem-
perature before storing
Insert smaller quantities of food to
be cooled at any one time
Provide inside cool air circulation
Set a higher temperature
Wrap the products better
Check if the doors close well and
the gaskets are undamaged and
clean
Set a warmer temperature
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean
Insert smaller quantities of food to
be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them
Set a warmer temperature
electrolux 9