Husqvarna W436 Operator's Manual page 25

Replacing Caster Pivot Bearing
Bushings
1. Turn the engine off. Remove the ignition
key. Remove the ignition wire from the
spark plugs.
2. Raise and securely support the front of the
mower deck.
3. Remove lynch pin, spacer bushings,
washer and caster yoke and wheel
assembly.
4. Remove and discard upper and lower
bushings.
5. Install new bushings.
IMPORTANT Do not allow washer to sit
on caster yoke. It must be on top of the
height-of-cut spacer bushings
6. Install caster yoke and wheel assembly,
washer, spacer bushings and lynch pin.
7. Apply grease to grease fitting.
Grease Fitting
Spacers
Lynch Pin
Spacers
Spacer Bushing
Spacer Bushing
Washer
Caster Yoke
Wheel
Spacer
Wheel Assy
Electrical Service
Replacing Fuse
IMPORTANT Avoid damage! When
replacing fuses use only 25-amp fuses to
avoid damage to the circuit.
The machine is equipped with one 25-amp
fuse to protect the charging circuit. This fuse is
located on the main harness, near the engine
ground. Replace with an automotive type 25-
amp fuse.
1. Remove defective fuse from socket.
2. Check metal clip in fuse window and
discard fuse if clip is broken.
3. Install new fuse into socket.
- 25 -