Related Manuals for Icom iFR5200H
Summary of Contents for Icom iFR5200H
- Page 1 INSTRUCTION MANUAL VHF FM REPEATER iFR5200H UHF FM REPEATER iFR6200H This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.
-
Page 2: Important
Place the repeater in a secure place to avoid inadver- tent use by children. For U.S.A. only CAUTION: Changes or modifications to this re- peater, not expressly approved by Icom Inc., could void your authority to operate this repeater under FCC Square fuse regulations. (FGB01 30A) -
Page 3: Table Of Contents
Thank you for choosing this Icom repeater. The IC- EXPLICIT DEFINITIONS ..........i FR5200H/IC-FR6200H uhf fm repeaters designed and built with Icom’s state of the art technol- SUPPLIED ACCESSORIES........i ogy and craftsmanship. With proper care, this product PRECAUTIONS ............i should provide you with years of trouble-free opera- FORWARD .............. -
Page 4: Safety Training Information
Electromagnetic Interference/Compatibility comply with the following three conditions: 1. The transmitter antenna gain shall not exceed 0 During transmissions, your Icom radio generates RF dBi. energy that can possibly cause interference with other 2. IC-FR5200H: devices or systems. - Page 5 Interférence électromagnétique et compatibilité tions suivantes: En mode de transmission, votre radio Icom produit de 1. Le gain de l’antenne du radio émetteur ne doit pas l’énergie de RF qui peut provoquer des interférences dépasser 0 dBi.
-
Page 6: Panel Description
PANEL DESCRIPTION n Front panel Function display q INTERNAL SPEAKER u MICROPHONE CONNECTOR [MIC] Monitors received signals. This 8-pin modular jack accepts the optional micro- phone. w VOLUME CONTROL [VOLUME] (p. 7) KEEP the [MIC] connector cover attached to the Adjusts the audio output level. -
Page 7: D Function Display
PANEL DESCRIPTION D Function display I C O M I n c . q SIGNAL STRENGTH INDICATOR r COMPANDER INDICATOR Indicates relative signal strength level. Appears when the compander function is activated. w LOW POWER INDICATOR t SCRAMBLER/ENCRYPTION INDICATOR Appears when low output power is selected. Appears when the voice scrambler/encryption function is activated. -
Page 8: D Accessory Connector
PANEL DESCRIPTION D Accessory connector Pin No. Pin Name Description Specification No connection — Output terminal for serial communication data. — Input terminal for serial communication data. — Output terminal for request-to-send data. — Input terminal for clear-to-send data. — No connection —... -
Page 9: Installation And Connections
Ground i Input port for PC programming CAUTION: DO NOT short pin 1 to ground as this can damage the internal 8 V regulator. DC voltage is applied to pin 1 for microphone operation. Only Icom micro- phones are recommended. -
Page 10: Front Panel Connection
INSTALLATION AND CONNECTIONS n Rear panel connection PC console AC outlet DC power supply to an Ethernet port 13.8 V (at least 20A) ACC CONNECTOR (p. 3) Black Used for external equipment control. [RX ANT] [TX ANT] (p. 4) (p. 4) AC power cable DC power cable... -
Page 11: Power Supply Connection
INSTALLATION AND CONNECTIONS n Power supply connection n Mounting the repeater D Using the supplied handle Make sure the repeater’s power is turned OFF when connecting a DC power cable. The supplied handles are available for mounting the repeater into a 19 inch rack. The handles can be in- CAUTION: Voltages greater than 16 V DC will dam- stalled to the repeater’s front panel. -
Page 12: Operation
OPERATION n Receiving and transmitting D Base station operation D Repeater operation Receiving Ask your dealer for details of the repeater’s program- q Push [POWER] to turn the power ON. ming. w Set the audio and squelch levels. ➥ Rotate [SELECT]* fully counterclockwise in ad- ➥... -
Page 13: Maintenance
If you are unable to locate the cause of a problem The following chart is designed to help you correct or solve it through the use of this chart, contact your problems which are not equipment malfunctions. nearest Icom Dealer or Service Center. PROBLEM POSSIBLE CAUSE SOLUTION REF. -
Page 14: Options
Icom repeater. Icom is not responsible for the destruction or damage to an Icom repeater in the event the Icom repeater is used with equipment that is not manufactured or ap- proved by Icom. -
Page 15: Information
INFORMATION • ABOUT VOICE CODING TECHNOLOGY The AMBE+2™ voice coding Technology embodied in this product is protected by intellectual property rights including patent rights, copyrights and trade secrets of Digital Voice Systems, Inc. This voice coding Tech- nology is licensed solely for use within this Communi- cations Equipment. - Page 16 A-?????-?? Printed in Japan © 2014 Icom Inc. 1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan Printed on recycle paper with soy ink.