Replacing The Cutting Unit; Battery Removal - Philips T970 AccuVac User Manual

◗
It is recommended that the Hair Collection
Chamber be emptied and cleaned out after
each use.
◗
Do not operate the Trimmer with the Hair
Collection Chamber removed.
Trimmer:
1 Make sure the Trimmer is switched OFF
and disconnected from the electrical
outlet.
2 Remove the Guide Comb Attachment.
3 Remove the cutting unit (fig. 10).
4 Clean the cutting unit and the inside of the
Trimmer with the brush supplied (fig. 16).
5 Re-attach the cutting unit and the Guide
Comb into place on the Trimmer (fig. 17).

Replacing The Cutting Unit

If your cutters and filter become damaged or
worn, do not continue using the Trimmer.
Replace cutters and/or filter immediately.
This Trimmer has no other user-serviceable
parts. Any other service should be performed
by an Authorized Norelco Service Location.
Assistance
For Assistance or the Authorized Norelco
Service Location nearest you, call toll free:
1-800-243-3050
or visit our website: www.norelco.com
Authorized Norelco Service Location
information is available 24 hours a day, 7 days a
week.
Storage
◗
Be sure Trimmer is turned off and remove
cord from outlet and Trimmer before
storing in a safe, dry location where it will
not be crushed, banged, or subject to
damage.
◗
Do not wrap cord around Trimmer when
storing.
◗
Store Cord in a safe location where it will
not be cut or damaged.
◗
Do not place or store Trimmer where it
can fall or be pulled into a tub or sink,
water or other liquid.

Battery Removal

◗
This Trimmer contains rechargeable Nickel-
Cadmium batteries, which must be disposed
of properly.
◗
Batteries should only be removed when
Trimmer is to be discarded.
◗
Refer to Battery Removal instruction sheet
for directions on removing the rechargeable
batteries.