Wiring With Cables - ABB ACS550-01 User Manual

18

Wiring with Cables

1. Open the appropriate knockouts in the
conduit/gland box. (See "Conduit/Gland Kit"
above.)
2. Install the cable clamps for the power/motor
cables.
3. On the input power cable, strip the sheathing
back far enough to route individual wires.
4. On the motor cable, strip the sheathing back
far enough to expose the copper wire screen
so that the screen can be twisted into a pig-
tail. Keep the short pig-tail short to minimize
noise radiation.
5. Route both cables through the clamps.
6. Strip and connect the power/motor wires, and
the power ground wire to the drive terminals.
See "Power Connections" on page 20.
7. Connect the pig-tail created from the motor
cable screen.
8. Install conduit/gland box and tighten the cable
clamps.
9. Install the cable clamp(s) for the control
cable(s). (Power/motor cables and clamps not
shown in figure.)
10. Strip control cable sheathing and twist the
copper screen into a pig-tail.
11. Route control cable(s) through clamp(s) and
tighten clamp(s).
12. Connect the ground screen pig-tail for digital
and analog I/O cables at X1-1.
13. Connect the ground screen pig-tail for RS485
cables at X1-28 or X1-32.
14. Strip and connect the individual control wires
to the drive terminals. See "Control
Connections" on page 20.
15. Install the conduit/gland box cover (1 screw).
Installation
ACS550 User's Manual
2
1
6
6
3
8
8
9
12
14
11
X0004
7
4
IP2001
X0005
X0006
IP2003