ABB ACS550-01 User Manual page 14

14
Motor compatibility
The motor, drive and supply power must be compatible:
specification
Motor type
Nominal current
Nominal frequency
Voltage range
Insulation
Tools required
To install the ACS550 you need the following:
• screwdrivers (as appropriate for the mounting hardware used)
• wire stripper
• tape measure
• drill
• for installations involving ACS550-U1, frame sizes R5 or R6 and IP54 / UL type
12 enclosures: punch for creating conduit mounting holes
• for installations involving ACS550-U1, frame size R6: appropriate crimping tool
for power cable lugs. See section
on page 281.
• mounting hardware: screws or nuts and bolts, four each. The type of hardware
depends on the mounting surface and the frame size:
Suitable environment and enclosure
Confirm that the site meets the environmental requirements. To prevent damage
prior to installation, store and transport the drive according to the environmental
requirements specified for storage and transportation. See section
conditions
Installation
Motor
3-phase induction motor
Motor value is within this
range: 0.2...2.0 · I
(I = drive heavy duty
2hd
current)
10...500 Hz
Motor is compatible with
the ACS550 voltage range.
500...600 V drives: Either
the motor complies with
NEMA MG1 Part 31, or a
du/dt filter is used between
the motor and drive.
Frame size Mounting hardware
R1...R4 M5
R5 M6
R6 M8
on page 300.
Verify
–
• Type designation label on drive, entry for
Output I
2hd
• Type designation on drive and rating table in
chapter
–
208...240 V (for ACS550-X1-XXXX-2) or
380...480 V (for ACS550-X1-XXXX-4) or
500...600 V (for ACS550-U1-XXXX-6)
For ACS550-U1-XXXX-6
Power terminal considerations – R6 frame size
#10
1/4 in
5/16 in
ACS550-01/U1 User's Manual
Reference
, or
2hd
Technical data on page 271.
Ambient