Indoor Unit (Setting By Simple Remote Controller) - Fujitsu AUYG07LVLA Design & Technical Manual

5-5.

INDOOR UNIT (setting by simple remote controller)

The function settings of the control of the indoor unit can be changed by this procedure
according to the installation conditions. Incorrect settings can cause the indoor unit to
malfunction.
After the power is turned on, perform the Function Setting according to the installation
conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting
Number.
Settings will not be changed if disable numbers or setting numbers are selected.
This function cannot be used on secondary units.
PREPARATION
(1) Turn on the power through the Branch box.
Before turning on the power of the indoor units, make sure the piping air-tight test and vacuuming have been
conducted.
Also check again to make sure no wiring mistakes were made before turning on the power.
Branch box
Breaker ON
- (06 - 80) -
Indoor
units
6. SYSTEM DESIGN